First thing was a full cavity sealing. Plenty of wax was spread.
Stone guards 
and mud shields 
are trial fitted 
As well as bracket 
and battery tray 
Original bolts even in hidden places 
Lower engine frame to bulkhead 
The inside of the bulkhead is always the first thing to assemble.
Heater pipes, 
Step 2, …hose must be attached before wiper installation 
Screen jet hose 
original T connector 
full wiper rack 
the early rough rest position setter 
Mind the two outer spindles which are handed. Short is right for LHD 
3 original early non metal 
Original, see number
Interior
- Tail gate aperture
- Two retainer plates at back of roof
- Fitting wheel arch covers and side panels
- Sound and heat insulation
- fitting side boxes
- Vinyl on inner flange for boot extension board
- Vinyl on floor cross member
- fitting and installing cantrails
- fitting seal retainer
- installing rubber seals
- installing tail gate opener
- Fitting sill covers
- Fitting food area side covers
- installing side panels
- Installing B Posts
- 1/4 light windows
- installing door assembly
- Fitting tail gate